A device that has a power amplifier and speaker in a case (or in separate cases) to reproduce the signal put out by an electric instrument (such as an electric guitar) and to allow the instrument to be heard.
Boom Stand
A microphone stand equipped with a telescoping support arm to hold the microphone.
BNO Acoustics QT-5 Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Cord (Speaker, Mic, Instrument)
Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
BNO Acoustics R-10 Speakers Basic Session
The First session in recording an audio production to record the Basic Tracks.
CPU
Abbreviation of Central Processing Unit (The main "brain" chip of a computer or the main housing of a computer that contains the "brain" chip).
Link
(Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o
Engineer
1) A technician in charge of a recording session; Also called Recording Engineer.
2) A person with an engineering degree.
3) A person with sufficient experience in the field to be equivalent to the education one would receive earning an engineering degree.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.