BNO Acoustics R-10 Generating Element

The portion of the microphone that actually converts the movement of the diaphragm into electrical current or voltage changes.

Condenser
An older term meaning the same thing as Capacitor (an electronic device which is composed of two plates separated by an insulator and can store charge) but sill in common use when referring to a microphone's active element.

BNO Acoustics TS-10 Cut
1) One selection (one song) on a pre4ecorded music format.
2) A term with the same meaning as Mute (to turn off a channel or a signal).
3) To reduce gain of a particular band of frequencies (with an equalizer).
4) To not pass a particular band of frequencies (said of a filter)

Feed
To send an audio or control signal to.

BNO Acoustics HD-70 Gain
1) Knob usually found at the top of each input channel on the soundboard. Used to set input levels of the separate channels to relatively equal positions.
2) The amount of increase in audio signal strength, often expressed in dB.

Beats Per Minute BPM
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song.

Hypercardioid Pattern
A microphone pick up sensitivity pattern where the least sensitive pick up point is more than 90 degrees but less than 150 degrees off axis (usually 120 degrees).

Compressor
1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.