1) Effect used to squash the sound together. Used properly, it can take the edge off or your sound. Used improperly, it can take the life right out of your system and make it sound like an MTV mix.
2) A piece of sound processing equipment that ensures all wanted signals are suitably placed between the noise and distortion levels of the recording medium. It evens out the unwanted changes in volume you get with close-miking, and in doing so, adds punch to the sound mix. A Limiter is used to stop a signal from exceeding a preset limit. Beyond this limit, the signal level will not increase, no matter how loud the input becomes. A Limiter is often used to protect speaker systems (and human ears) by preventing a system from becoming too loud.
Light Emitting Diode
A light that allows current to flow in one direction only and emits light whenever a voltage of a certain level or beyond is applied to it.
BNO TS-10 Information Bits
The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes.
Folded Horn
A speaker design where the speaker points back into the cabinet and bounces around finally coming out large ports in the front. It is intended to maximize low frequencies in a relatively small cabinet.
BNO Acoustics SQ-9 Equal Loudness Contours
A drawing of several curves showing how loud the tones of different frequencies would have to be played for a person to say they were of equal loudness.
Expander
A device that causes expansion of the audio signal.
Line In (Input, return)
Where a signal enters the board or component.
BPM
An abbreviation of Beat Per Minute (the number of steady even pulses in music occurring in one minute and therefore defining the tempo).
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.