The two track stereo master tape which was mixed from the multitrack master.
Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
BNO Acoustics SQ-9 High-Pass Filter
A device that rejects signals that are below a certain frequency (called the cut-off frequency) and passes signals with frequencies that are higher.
Diaphragm
A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.
BNO Acoustics R-10 Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other electrons) and attracts opposite (positive) forces.
Expansion
The opposite of compression; for example, an expander may allow the signal to increase 2 dB every time the signal input increased by 1 dB.
Dynamic Mic
Robust type of microphone which picks up the sound on a diaphragm connected to a coil of wire which moves within a magnet. An alternating current is induced into the wire which provides the electrical output. Most dynamic mics have low output impedance of 200 Ohms. See Condenser Mic.
Gain Reduction
The working of a limiter or compressor reducing gain during high-level passages.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.