Wednesday, November 25, 2020

BNO Acoustics XV-16 Feedback

1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.

Intermodulation Distortion
Distortion caused by one signal beating with another signal and producing frequencies that are both the sum and the difference of the original frequencies.

BNO Acoustics 6k-52 AES/EBU
Professional Interface A standard for sending and receiving digital audio adopted by the Audio Engineering Society and the European Broadcast Union.

Distorted
The way your PA sounds just before it blows up. Fuzzy and scratchy. If you hear this, it either means you have something hooked up wrong, or something in the system is going bad. It could be anything from your super expensive soundboard to a five dollar patch cord.

BNO Acoustics YM-44 Console
A set of controls and their housing, which control all signals necessary for recording and mixing.

Bridge
The bridge assembly, or just "bridge" is an area on the face of the guitar where the string meet or are connected to the face.

Lead Sheet
A written chart showing the melody, lyrics and chords of a tune with full musical notation.

Bi-Amplification
1) A way of optimizing the efficiency of a speaker system by separately amplifying the High Frequency (HF) and Low Frequency (LF) portions of the sound signal and sending them down two pairs of cables to the speaker. Multipin Speakon connectors have been developed to do this.
2)The process of having of having low-frequency speakers and high-frequency speakers driven by separate amplifiers.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.