The reel that the tape is wound onto in the play mode.
Pitch Control
Facility on some sound playback devices for changing the speed of playback, and thus the pitch or frequency of the sound, to match an existing sound, or to fit a particular timeslot. Some Professional CD players have tempo controls which speed up the playback, and then compensate for the resulting increase in frequency using a pitch change. This results in the ability to match the beat of a CD in a disco situation, without the "Pinky and Perky" effect.
BNO Acoustics GT-60: Tinny
Used to describe a sound with too many highs and mids and not enough lows.
Microphone
A transducer which converts sound pressure waves into electrical signals.
Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Pre Fader
A placement of a send control (or other control) before the main channel fader.
Regulated Power Supply
A device to supply power to electronic equipment whose output voltage will not fluctuate when more equipment is turned on, or if there is a change in voltage of the power line.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.